Yajing one-way mirror film - providing you with sufficient privacy protection ● Have you encountered the following problems? During the day, do people look at houses when passing by? Can harmful ultraviolet rays cause furniture to fade and harm your skin? Do you need to pay higher electricity bills because the room will become hot due to strong sunlight? How will black unidirectional reflective film help solve these problems? During the day, you can get good privacy protection because people outside cannot see things through mirror like windows. This reflective film can block 98% of ultraviolet and 85% of infrared rays, helping to protect furniture and people. It can suppress 90% of visible light, soften strong sunlight, and keep the room cool. What are the characteristics of this reflective window? Magic Mirror Effect: The characteristic of the one-way mirror window being tightly attached is that it has a mirror effect on the bright side. During the day, it is on the outside window to provide privacy, while at night it is the opposite. UV suppression; Glare control: It can reflect most of the ultraviolet rays and strong sunlight, protecting you and blocking heat. Easy to install: It is easier to apply film on windows. It becomes non sticky after being wet with a large amount of water. After drying, it will stick tightly to the window. Comfortable; Affordable: Anti UV, anti glare, no need to worry about strong direct sunlight! Unidirectional window film can block most harmful ultraviolet and infrared rays, as well as visible light. It helps prevent furniture from fading and saves energy costs. Privacy note: Mirror effect and daytime privacy. During the day, when the outside light is stronger than the inside light, the outside glass will present a mirror effect. Therefore, people cannot see inside, and sitting at home can enjoy the beautiful scenery outside, ensuring your family privacy. Glare control and increased comfort - annoying glare on TVs and computers? Our unidirectional film can help you work effectively and relax comfortably, significantly reducing eye fatigue and discomfort caused by excessive light. When holding broken glass, our unidirectional film can provide strong force to fix glass fragments together, preventing splashing and accidental injury. Installation instructions: 1. Measure the surface and cut the film. Leave an additional inch margin on each side for easy adjustment. 2. Thoroughly clean the target surface to ensure that it is sufficiently clean and free of dust. 3. Peel off the transparent backing film along the short edge. 4. Spray a large amount of water on one side of the adhesive and the surface of the car window (very important!!!), and then apply the film to the car window. 5. Gently flatten the film with a scraper and gradually squeeze out the bubbles. 6. Cut off the edges and flatten the film with a piece of cloth. Attention to you: Please spray a large amount of water during the installation process, which is the key to success. Kind reminder: 1. Window film can only be applied to flat, smooth, and clean glass. The most important thing is to ensure that your windows are thoroughly clean, and every bit of dirt may produce bubbles; Before fully preparing to use the window film, do not remove the backing from the window film. Dust may make it difficult for the film to adhere. When peeling off the backing, it should be done smoothly and slowly to avoid any wrinkles. You can remove bubbles, but you may not be able to remove creases; When applying the film, please cover the glass surface completely to avoid light leakage. This may cause the glass to crack after uneven heating; 4. If there is a large temperature difference between indoor and outdoor, please do not use window film (it is recommended to control the temperature difference to around 30 degrees); Do not use laminated glass.
4.0 aus 5 baséiert op 4,274 Rezensiounen 
