LED High-brightness Work Light 180°Rotating Purple Sensor Warning Emergency Hat Clip Fishing Light

Model T17 Light bulb 5*LED main lights (1*white light + 2*yellow light + 2*red light) + 8*LED side lights (6*white light + 2*purple light) Product size/net weight 8.3*4*3.5CM 63G Box size/gross weight 11.5*7.5*4.2CM 92G Material PC Switch Dual push-button switch (position switch + sensor switch) Battery Built-in 800mAh polymer battery Charging method Type-C USB charging Charging time/battery life Charging time: 2 hours Battery life: 4-10 hours Gear position Nine modes: Main light 2*LED yellow low light - 2*LED yellow high light - 1*LED white high light - 1*LED white high light + 2*LED yellow high light simultaneously on - 2*LED red light - Switch side light 6*LED white low light - 6*LED white high light - 6*LED white light + 2*LED red light alternating flash - 2*LED purple light Any setting can be detected. If you stay at any setting for 8 seconds and then press again, the device will turn off Zoom mode None Waterproof rating IPX4 Lumen/Range 100-150LM 10-50M Features Clip-on lamp, the clip can rotate 360 degrees, multiple light sources, sensor-controlled, the lamp head can be adjusted 180 degrees up and down, with purple light Indicator light Four LED power indicators. The LED power display flashes when charging The package contains Flashlight + USB cable + blister pack + color box 1. Instructions for use: 1. Check the battery: Ensure the battery has power and is installed in the correct direction in the flashlight; 2. When using a flashlight, choose the battery according to the flashlight's voltage and battery requirements; do not use the wrong battery to avoid damaging the circuit board. Do not use batteries of different models and voltages simultaneously 3. During use, when the brightness of the flashlight changes significantly, turn off the flashlight to prevent over-discharging of the battery and recharge it promptly. Pay attention to the battery's waterproof, moisture-proof, and drop-proof features. When charging, according to the charger's charging speed, remove the battery in time after the indicator light changes, and do not overcharge 4. Batteries that are not used for a long time should be fully charged and kept in that state. It is recommended to recharge and discharge them again approximately every three months to avoid chemical corrosion 5. Keep the inner wall of the lamp cup clean; absolutely do not wipe it with your hands or hard objects. To remove fingerprints from the lens, use a cotton swab dipped in lens cleaner and gently wipe it 6. Do not expose the flashlight to sunlight, water, chemicals, or corrosive gases for extended periods to avoid damage to the flashlight 7. Non-professionals should not disassemble the flashlight to avoid damaging the circuit board. 2. Precautions: 1. Do not shine light directly into the eyes to avoid causing damage to them 2. Please do not use it with excessive voltage; the voltage should not exceed 4.2V. Do not place the battery upside down, otherwise the circuit board will be damaged 3. When charging, please pay attention to the positive and negative poles of the charger and avoid overcharging or over-discharging the battery to prevent damage to its lifespan (charging time is generally 5-8 hours) 4. When using the flashlight, check that all the screws are tightly tightened and not loose, otherwise it may result in the flashlight not lighting up or only lighting up dimly 5. The flashlight should be kept away from sunlight or high-temperature environments. After stopping use, please remove the battery, charge it fully, and store it in a cool, dry place ； 6. The company's flashlight has the ability to withstand water splashes in daily life and will not cause problems under normal rain conditions, but it does not have the ability to be submerged in water. Please do not use this flashlight for diving or leave it in water basins or bathtubs for extended periods of time 7. To maintain the smooth rotation of the O-ring (sealing rubber ring) and threads, please apply petroleum jelly oil or similar substance to their surface 2-3 times a year. 3. Charging instructions: Insufficient power should be replenished promptly to avoid affecting the battery's lifespan, and the battery should also be charged during long-term storage.